|
16 Gauge Copper Wire Needle Nose Pliers |
 |
 |
 |
 |
| Follow the photo steps and the measurements given below each photo. | 1/2 inch fold | Bend at base of fold into a V | 1/2 inch fold | 1/2 inch until next bend |
 |
 |
 |
 |
 |
| 1/2 inch fold | 3/4 inch until slight curve and then 1/4 inch more until slight bend which will be base point of antler. | Another slight bend after 1/4 inch more and then a 1/2 inch fold | 1/2 inch from top of the bend of the fold, bend into a V | 1/4 inch fold, then direct wire
back to base point and bend wire down.
Trim wire 1/4 inch from base point. |
© Copyright 2004 by AOK Corral Craft and Gift Bazaar.
All rights reserved.
These projects are for your personal use only and may
not be reprinted or copied without written permission from AOK Corral.